Chapter 2 G.SHDSL Testing
Testing in G.SHDSL through mode
Testing in G.SHDSL through mode
Selecting
through mode
Setting test
parameters
34
In through mode, you can use the HST-3000 to replace the
customer's G.SHDSL modem to help sectionalize troubles.
You can operate the HST in either STU-R through or STU-C
through mode.
The through mode test involves the following steps:
– selecting through mode
– setting test parameters
– connecting to the line
– performing the tests
The first step for the test is to select a through mode.
To select a through mode
– From the G.SHDSL Measurements menu, select one of
the following modes:
– G.SHDSL STU-R Through
– G.SHDSL STU-C Through
The Summary statistics appear. The HST is in through
mode.
Before you begin testing, you must make sure that the
HST-3000 setup matches the parameters of the line that you
are testing. The following parameters can be changed:
– General modem parameters (see
modem parameters" on page
– Data parameters (see
page
13)
– Ping parameters (see
page
21)
HST-3000 G.SHDSL Testing User's Guide
"Setting general
10)
"Setting data parameters" on
"Setting ping parameters" on