Rear Panel - Panasonic AW-RP50E Operating Instructions Manual

Parts and their functions
 

Rear panel

 POWER switch [POWER]
When the POWER switch is set to the ON position,
the POWER indicator () lights, and the unit can be
operated.
 TO PAN/TILT HEAD 1 to 5 connectors
[TO PAN/TILT HEAD 1 to 5] (RJ-45)
Connect the remote cameras to these connectors using
straight cables (category 5 or above).
 LAN connector [LAN] (RJ-45)
(10Base-T/100Base-TX)
Connect the remote camera, switcher or host computer
that supports IP connections to this connector using a
LAN cable.
When directly connecting a device to the unit, use a
crossover cable (category 5 or above).
When making the connection through a hub (switching
hub) or other device, use a straight cable (category 5 or
above).
 TALLY/GPI input/output connector [TALLY/GPI]
(D-sub 15-pin, female, inch thread)
 Refer to "Control interface for external devices"
(<Operations and Settings> Operating Instructions).
SIGNAL GND
TO PAN/TILT HEAD
TALLY/GPI 5 4 3
13 (R)
POWER
ON
12V IN
2 1 LAN
BOOT
SV NM
 DC IN socket [12V
The AC adapter provided with the unit is connected to
this socket.
 Ground terminal [SIGNAL GND]
Connect this to the system's ground.
 SERVICE switch [SV/NM]
This switch is used for maintenance purposes.
Normally, it is set at the "NM" position.
 Wire fastening fitting
An anti-theft wire available on the market can be fastened
to this fitting to prevent theft.
IN] (DC 12 V)