Changing The Ip Addresses Of The Remote Cameras - Panasonic AW-RP50E Operating Instructions Manual

Connections
Changing the IP address on the unit to match the IP
address of the remote camera or switcher
[Remote camera settings]
The unit sets the IP addresses for the remote cameras
that have been detected by associating them with camera
numbers whose connection setting is set to "NoAsign".
Connection settings:
On the [SYSTEM] menu, select [CAMERA CTL], and
then display items [CAM1] to [CAM100].
Setting or changing IP addresses:
On the [SYSTEM] menu, select [CAM IP ADR], and
then display items [CAM1] to [CAM100].
Example:
 Three remote cameras are in operation.
 An additional remote camera with an IP address
of "192.168.000.020" is newly introduced (and
becomes remote camera E).
 Remote camera E is detected.
 In [CAMERA CTL], the [CAM4] item is set to
"NoAsign".
In the above example, on the [SYSTEM] menu, in
[CAM IP ADR], the IP address of the [CAM4] item is
set to "192.168.000.020".
 Subnet mask, default gateway, and port number
settings are the same as those for the unit.
[Switcher settings]
On the [SYSTEM] menu, in [SW CTL], if the [SW] item
is set to "NoAsign", the IP address for the switcher will
be set in the [IP:SW] item from [SW IP ADR] on the
[SYSTEM] menu.
Note
If different subnet mask settings are used for unit and
remote camera, no operations using the network will be
possible.
1
Connect the additional remote cameras and
the switcher to be introduced and the unit to
the network within the same subnet.
2
On the [SYSTEM] menu, select [AUTO SET
IP], and display [AUTO SETUP]. Then select
"KEEP", and press the F2 dial.
1. AU TO S ET UP
Both the number of devices (all remote cameras and the
switcher) currently being managed by the unit and the
number of new devices detected are displayed on the
LCD panel.
C : 1 / 4 S: 0 / 1
C : 1 / 4
Number of devices currently managed by the
unit + Number of new devices detected
Number of new devices detected
 Memo 
  If the number of new devices detected exceeds
the number of devices that can be registered
(100 remote cameras and 1 switcher), [C/S OVER!]
will be displayed at the bottom of the LCD panel.
Automatic IP address setting can be performed even
in this state, but IP addresses will be set only for the
number of devices that can be registered.
  The number displayed for "Number of new devices
detected" may be lower than the actual number of
devices to be set, due to a cause such as the remote
cameras or switches not being powered on. In this
case, eliminate the cause of the problem, select
"RETRY", and then press the F2 dial to retry the
operation.
The number of units to be added can be updated.
27 (S)
K EE P
Y E S
C: Remote camera, S: Switcher
C:20/100 S:1/1
C/S OVER! YES
C : 20 / 2 0 S : 1 / 1
R E TR Y