Changing The Ip Addresses Of The Remote Cameras - Panasonic AW-RP50E Operating Instructions Manual

Connections
3
Turn the F2 dial, select "Yes," and then press
the F2 dial.
This starts the "Auto IP setting" process.
When "Auto IP setting" has been initiated, the progress
is shown by the number of displayed dots which are
reduced one by one.
S E T U P I P
When all the operations have been completed
successfully, "COMPLETE!" is displayed.
S E T U P I P
C OM P L ET E !
The remote cameras can now be operated from the unit.
The function for linking the switcher with the unit
becomes available for use at this point.
 Memo 
  The "IP Duplication!" message is displayed if there is
duplication between the IP addresses of the devices
in operation and the IP addresses of the additional
remote cameras to be introduced.
The IP addresses are not set for those remote
cameras whose IP addresses are in duplication.
S E T U P I P
I P D u p li c a t io n !
Check the IP addresses, and then retry the "Auto IP
setting" operation.
  If the IP addresses were not set successfully,
"SET UP ERR!" is displayed.
S E T U P I P
The cause of the problem is likely a network
malfunction.
Check the connection status of the hub and LAN
cables, and then retry the "Auto IP setting" operation.
S ET U P E R R !
 Changing the IP addresses of 
the remote cameras
 Setting the IP addresses 
On the [SYSTEM] menu, select [CAM IP ADR], and display
[IP:CAM1] to [IP:CAM100]. The IP addresses of the camera
numbers can now be changed.
Even when "NoAsign" or "Serial" has been selected as
the [CAM1] to [CAM100] setting of [CAMERA CTL] on the
[SYSTEM] menu, the IP addresses can still be changed.
1.I P: CAM 1
192 .1 68. 000 .1 00
The IP addresses are set for all the camera numbers
[CAM1] to [CAM100].
Initial values:
CAM1 (192.168.000.010)

CAM100 (192.168.000.109)
 Memo 
If the unit's IP address has been changed using the [IP
ADDRESS] item of [NETWORK] on the [SYSTEM] menu,
the IP addresses of the camera numbers which were
set to "NoAsign" for the [CAM1] to [CAM100] item of
[CAMERA CTL] on the [SYSTEM] menu and which are
higher than the unit's IP address, will be automatically
re-set in the sequence of the camera numbers set to
"NoAsign" starting with the lowest number.
When the IP addresses are changed, a check for IP address
duplication is conducted.
A check is carried out to verify whether there is any
duplication with the IP addresses of the camera numbers
which were set to "Network" for the [CAM1] to [CAM100]
item of [CAMERA CTL] on the [SYSTEM] menu.
If duplication is found, the "Duplicate!" is displayed for three
seconds, and the IP addresses cannot be set.
1.I P: CAM 1
28 (E)
▼
Du pli ca te!