Selecting The Remote Cameras To Be Operated - Panasonic AW-RP50E Operating Instructions Manual

Selecting the remote cameras to be operated

Up to five remote cameras to be operated can be selected
using the CAMERA STATUS/SELECTION buttons.
When one of the CAMERA STATUS/SELECTION buttons
1 to 5 is pressed, the indicator of the corresponding button
lights.
Indicator lighting statuses and remote camera statuses
Indicator
lighting status
  No remote camera has been assigned to the corresponding button.
OFF ("NoAsign" is set for the remote camera connection.)
  The power of the remote camera has not been turned on.
ON The remote camera is in the standby status.
(orange)
Blinking Five other controllers are connected to the remote camera so even when the remote
(orange) camera has been selected from the unit the selection is rejected.
ON The unit is now connected with the remote camera.
(green)
Blinking Another device (AW-RP50) has selected the corresponding remote camera.
(green)
ON The image of the corresponding remote camera is now on the air.
(red) (The OA tally signal is received over the network or at the GPI input connector.)
Blinking Another device (AW-RP50) has selected the corresponding remote camera, and the
(red) image of the remote camera is now on the air.
Up to 100 cameras can be divided into 1 to 20 groups by
menu operations, and controlled by the unit.
The selection procedure is described below.
1
Set the MENU button to ON.
Press the MENU button and light its indicator.
2
Set the PRESET MEMORY/MENU 8 button
(CAMERA) to ON.
When the button is pressed and its indicator is lit, the
[CAMERA] menu is displayed on the LCD panel.
[1 ] GR O UP
1 2 3
MENU PAGE GAIN/PED R/B GAIN R/B PED
6 7 8
STORE DELETE DETAIL SCENE/MODE CAMERA
PRESET MEMORY / MENU
1 2 3
IRIS AUTO
CAMERA STATUS / SELECTION
Remote camera status
▼
30 (R)
The statuses of the remote cameras assigned to CAMERA
STATUS/SELECTION buttons 1 to 5 can be identified by the
lighting statuses of the indicators above the buttons.
4 5
AWB/ABB SHUTTER F2 EXIT
9 10
SETUP SYSTEM USER1 USER2
4 5
PT ACTIVE
3
Press the F1 dial.
The GROUP SELECT item is displayed.
[1 ] G R O U P
Press the F1 dial.
1. G R O U P S E L E CT
4
Turn the F2 dial, select the group, and then
press the F2 dial.
The remote cameras assigned to the group selected here
can be selected using the CAMERA STATUS/SELECTION
buttons.
The unit and remote camera
connections
IP connection/Serial connection
IP connection/Serial connection
IP connection
IP connection/Serial connection
IP connection
IP connection/Serial connection
IP connection
▼
1