Air Filter; Windscreen Washer Liquid - Nilfisk-Advance City Ranger 2250 Operator's Manual

3.7 Cooler - continued
Preventing overheating
If the warning light is ON, all attachments must be
switched off and the engine must be run at half-throttle.
The air-intake grill in the rear screen must be cleaned and
the source of overheating located. Engine temperature
must fall to the normal level within 30 seconds. If you are
in doubt about the cause, contact your dealer.
Cleaning the water cooler
Described in section 3.1.

3.8 Air filter

Cleaning the air filter
A) When the City Ranger 2250 is operating in dirty and
dusty conditions, open the vacuum valve every day to get
rid of larger dirt and dust particles.
B) Open the air filter housing.
C) Remove the filter element.
D) Wipe the air filter housing with a clean cloth.
E) Carefully clean with compressed air from the inside.
G) Put the air filter element back and close the filter
housing. (Picture 1)

3.9 Windscreen washer liquid

During winter, check that the windscreen washer liquid
has frost protection properties.
A) The windscreen washer tank is in the cab, behind the
driver´s seat.
B) Pull the driver´s seat forward to access the windscreen
washer tank.
C) To add windscreen liquid, unscrew the cap, add
windscreen liquid and screw the filling cap on again.
(Picture 2)
Operator's Manual City Ranger 2250
Service and maintenance
1
Air filter housing
2
Windscreen washer liquid cap
Vacuum valve
49