General information
1.22 Fitting the cab/roll bar - continued
6. Insert the cable into position. (Picture 1)
7. Tilt the cab/roll bar back into position.
8. Re-insert the four bolts behind the driver's seat and
tighten. Due to tolerances, it may be necessary to guide
the holes into the correct position (remember seat belt
and lock). (Picture 2)
9. Connect the three connectors on the cables. (Picture 3)
10. Fit the filter and grate.
11. Attach the two rubber strips between the base plate
and cab frame (cab only). (Picture 4)
12. Attach the doors to the cab (cab only).
32
1
Insert the cables
2
Fit bolts
3
3 connectors behind grate
4
Rubber strips
Operator's Manual City Ranger 2250