Fitting The Cab/Roll Bar - Nilfisk-Advance City Ranger 2250 Operator's Manual

1.22 Fitting the cab/roll bar

1. To fit the cabin/roll bar, lift over the steering wheel and
seat.
To reduce lifting weight, remove the doors before lifting
the cabin. (Picture 1)
2. Insert the two bolts under the base plate and attach the
nuts (but do not tighten). (Picture 2)
3. Tip the cabin/roll bar forwards and chock in place so
that the sealing strip can be attached. (Picture 3)
4. Attach a new sealing strip. Ensure that the four bolts
behind the driver's seat can be inserted through the holes.
Trim off some of the width of the strip adjacent to the
holes if necessary.
5. Position spacers. (Picture 4)
Operator's Manual City Ranger 2250
General information
1
Lift cab/roll bar
2
Bolts under base plate
3
Chock, attach strip
4
Position spacers
31