Nilfisk-Advance City Ranger 2250 Operator's Manual page 14

General information
1.6 Steering column - continued
Instrument panel
4. The pre-heater light is activated when the ignition key is
turned, showing that the engine pre-heater is on. When the
light goes out, the ignition key can be turned all the way to
start the City Ranger 2250.
5. Handbrake indicator.
6. Charging light.
Normally lights on ignition or when the engine starts. If the
light stays on, stop the engine and find the cause. Check the
generator belt.
7. Dimmed headlight indicator.
8. Indicator-light indicator.
9. Hydraulic filter alarm (when lit indicates filter must be
replaced). Hydraulic oil low: Hydraulic oil required.
Note that the alarm device may be activated when the
temperature falls to under +5 °C. Check oil level. If this is OK,
restart the machine. The alarm device must deactivated after
no more than 15 seconds.
10. Oil alarm.
If the light is on during operation, stop the
engine immediately and check the oil. If the oil is low,
it must be topped-up immediately
11. Temperature alarm.
If on it indicates the engine temperature is too high. Switch off
all attachments and let the engine run on half-power (rpm)
for approx. two minutes. If necessary, clean the radiator grills.
The operating hydraulics will automatically disconnect when
the overheating alarm device is activated.
12. Air filter blockage alarm (optional).
13. Fuel tank indicator. Lights up when there is less than five
litres offuel left in the tank.
14. Fuel tank level.
15. Time/rpm/speed counter. Time shown on start-up
Automatically switches over to show rpm.
16. Shows rpm or km/h.
17. Engine temperature indicator.
Sound alarm activates in case of 6, 9, 10, 11, 12 and 13
14
1 120
2/3
95
1/3
Instrument panel – right
9
10
11
12
13
Instrument panel – left
14
2/3
1/3
Instrument panel – centre
Operator's Manual City Ranger 2250
8
7
70 6
45
5
4
1
2/3
1/3
16 17
1 120
95
70
45
15
120
95
70
4