Nilfisk-Advance City Ranger 2250 Operator's Manual page 38

Operator's manual
2.2 Start, drive and stop - continued
Turning off the City Ranger 2250
1. The PTO front and PTO rear contacts must be
disengaged.
2. Pull the throttle back so the engine is idling.
3. Push the brake pedal down (Picture 1), lift the parking
lock up (Picture 2) and release the brake pedal (See
Section 1.6).
4. Turn off the City Ranger 2250 by turning the key back to
the key-release position.
Operating with front attachments
Before the City Ranger 2250 can drive, the fitted
attachments must be lifted clear of the ground.
Pull the joystick back until the attachment is lifted all the
way. (Picture 3)
If longer transport distances are involved, the transport
lock must be activated (See Section 1.6).
Fitting attachments on the front and back
Read the operator's manual for the relevant attachment(s).
Connecting and disconnecting attachments
The engine must always be turned off before the
attachment is connected/disconnected.
The quick-shift of attachments is not designed to be
attached while the engine is running. Incorrect usage
will destroy the couplings and will not be covered by the
warranty.
The couplings and the area around the couplings must be
kept clean to avoid an accumulation of dirt.
(See section 3.1)
38
1
Brake pedal Drive pedal
2
Transport lock Parking lock
3
Joystick
Operator's Manual City Ranger 2250