Table of Contents
Advertisement
[Note 2]: This is only displayed if the communication module is set to "non-procedure (TCP
Client)".
[Note 3]: Only when the communication module is set to "Non-procedure (TCP)" or
"non-procedure (TCP Client)", the initial setting value becomes [9876].
Reference:
Setting the Start-up Status [Startup Setting] (p.347)
3.
Tap [OK].
The settings are confirmed and the Ethernet window closes.
Setting Communication Specifications (RS-232C/422 - Non-procedure)
Communication specifications such as communication speed and IP addresses are set for serial
interface (RS-232C/422 connection) communication.
Reference:
Setting Communication Specifications (Ethernet - Non-procedure) (p.435)
Important
Before setting the communication specifications, set the "Serial (RS-232C/422)" communication module to
●
"Normal" or "Normal (Fxxx method)", save the setting to the controller, and then restart the system.
Reference:
Setting the Start-up Status [Startup Setting] (p.347)
Use the same communication specification settings for the controller and the external device.
●
If the operation mode (FZ4-11
●
supported for line 1.
RS-422 is disabled on the FZ4-L35
●
Reference
During setting of communication specifications, input signals cannot be handled. However, the input status can
●
be checked with [confirmation].
Reference:
Checking Communication Status (Non-procedure) (p.441)
When data is output via serial communication, output is suspended while communication specifications are
●
being set.
1.
On the Main screen, tap the [System] menu - [Communication] - [RS-232C/422:Normal].
The Serial window is displayed.
FZ4 User's Manual
/H11
only) is set to [Multi-line random-trigger mode], this setting is not
series.
Controlling/Outputting through Serial Communication (Non-procedure)
7
439
Advertisement
Table of Contents
