During Operation - Omron FZ4 Series User Manual

Start-up is slow
Was the system connected to a LAN when started?
●
If the system is started while connected to a LAN, startup may take a longer time.

During Operation

Measurement results do not display on the monitor
Are windows other than the Main screen (the Edit Flow window, etc) displayed?
●
Are any setting windows open?
●
* A setting window is defined to be a window that opens separately such as the Edit Flow window
and the Scene Maintenance window.
The touch screen responds slowly
Are you tapping the touch screen continuously and quickly? If yes, the response to operation
●
may be delayed.
"NG (memory shortage)" is displayed in the "Detail result" area
8
Does the number of specific processing items, such as camera image input, exceed the limit?
●
Reference:
In the [Image view setting] of the "Control" area, "Image mode", "Positions"
and "Sub image" can not be changed.
Is the "Detail result" area active?
●
Reference:
Data cannot be saved
The data save may have failed because there was not enough free capacity in the flash memory
●
in the controller. The current scene group data in the controller memory is destroyed after the
restart. Immediately perform one of the recovery/avoidance procedures specified below.
●
●
576 FAQ
About Limits on the Number of Image Input Processing Items Used (p.612)
Displaying Flow and Detailed Results (p.85)
For example, reduce the memory usage and then save data again to the controller, delete
scenes, delete processing units, adjust the processing unit measurement area, or adjust
the sizes of registered models.
Evacuate the current scene group data to a USB memory.
FZ4 User's Manual