From factory, the dryer has been set to specific values for:
Time, temperature, cooling, reversing, etc.
The above parameters are changeable by reprogramming the Selecta PCB.
Selecta II PCB
Fig. 1 The PCB Module is located on the back of the operating panel, see the Service
Manual for the specific dryer.
In order to reprogramme the dryer it is necessary to switch the print board into
In programming mode the buttons on the operating panel are used for changing the
parameters. See page later in this section "Switching to service mode".
Auto Stop The tumble dryer stops automatically when the clothes are dry.
Apartment House Laundry - Communal laundries / Housing block laundries.
On Premises Laundry - Institutional laundries.
Printed Circuit Board.
Residual Moisture Control - The tumble dryer has residual moisture control.
Coin Meter Double
Coin Meter Single
CMSNCB Coin Meter No Coin Box
Electrolux Single System
Prepared for Card Reader
487 05 40 31