Changing P-Programs, Example - Electrolux T4650 Service Manual
Selecta ii
Hide thumbs
Also See for T4650:
- Service manual (70 pages) ,
- Installation manual (44 pages) ,
- Operating manual (24 pages)
Table of Contents
Advertisement
4
Changing P-programs
Following parameters determine how eg. program P1 is executed.
Parameter
Explanation
7.01
Residual moisture level in %.
7.10
Extra drying time, for how long the drying must carry on after 0%
is reached.
7.19
Time / Automatics, the program can be set with a specified time
period or with a non-time determined drying via the built-in
automatics.
7.28
Max outlet air temperature set-up, roughly represents
the temperature of the garments.
7.37
Drying time which might be set in 7.19.
7.46
Cooling down condition for temperature, the cooling down of
the garments stops when both conditions (7.46 / 7.55) are met.
7.55
Cooling down condition for time, the cooling down of the
garments stops when both conditions (7.46 / 7.55) are met.
7.64
Reversing during P-program on/off.
Example: Changing P1
Program P1 can be adjusted to the individual textiles which are to be used in the dryer.
The below example shows how to change the set up of program for drying thick lining
boiler suits in mixed fabric 65/5 with polyester lining.
7.01
00
7.10
15
7.19
01
7.28
60
20
7.37
7.46
5
7.55
10
7.64
01
4.26
4. Programmes
factory setting = 00% is maintained
extra drying time is set to 15 min
automatic program is maintained
outlet air temperature is set to 60°C (140°F)
factory setting = 20 min is maintained
max outlet air temperature is set to 5°C (95°F)
cooling down time is set to 10 min
factory setting = 01 is maintained
Service
manual
487 05 40 31
- Quick Links:
- Error Codes
Hide quick links:
Advertisement
Chapters
Table of Contents
