Excalibur AL-1670-B Operation Manual page 20

Installer Programmable Features (cont'd)
Feature #5 - Light Relay Function
Dome Light Output
Start
Ignition Output
Accessory Output
Status
Light Flash
The system has two built-in relays, which can be programmed to perform several different
functions� The primary function of this relay, is to operate the vehicle's dome, or interior
lighting as part of the system's operations� Optionally, if desired or needed, this relay can
be programmed for the other functions listed above�
Feature #6 Blue Satellite Port, Blue Wire Function
Ignition
Status / GWR
Defrost 0.8 sec Pulse
Defrost 10 min Pulse
Pulse After Engine Off (press LOCK & UNLOCK to program)
Horn
This determines the function of the Blue wire on the Blue satellite relay port�
The Status setting turns on briefly before the Ignition output and stays on during remote
start mode� The other pulse settings give a 0�8 second pulse under the selected condi-
tion� Defrost Pulse will send a pulse after start only when the cabin temperature is below
freezing (32 degrees F / 0 degrees C)�
Feature #7 - Starter Cranking Time
0.75 Second (press LOCK to program)
1.00 Second (press UNLOCK to program)
1.5 Seconds (press TRUNK to program)
2.25 Seconds (press START to program)
3 Seconds (press LOCK & UNLOCK to program)
Average (press TRUNK & START to program)
This feature determines the crank time of the 1st start attempt when in "Tachless" mode�
If the engine doesn't start on the first attempt, it will retry up to 3 more times extending
the crank time by an additional 0�2 second with each attempt� The "Average" setting will
sample the last 8 cranks (by ignition key) and average the crank time automatically for
increased accuracy�
Feature #8 - Door Lock/Unlock Outputs
0.8 Second Outputs
3 Second Outputs
Double Pulse Unlock Output
Total Closure Lock Output
This changes the system's doorlocking outputs to suite different vehicle requirements� The
total closure setting provides a 28 second lock pulse (press LOCK or UNLOCK is during
the pulse to stop it) and a 0�8 second unlock pulse�
Feature #9 Remote Start Lock Control
Off
Lock After Start
Unlock before start
Unlock Before RS & Lock After RS
This feature allows for OEM alarm/lock control in relation to remote start operations thus
eliminating extra wiring for OEM alarm control�
20
(press LOCK to program)
(press UNLOCK to program)
(press TRUNK to program)
(press START to program)
(press LOCK & UNLOCK to program)
(press TRUNK & START to program)
(press LOCK to program)
(press UNLOCK to program)
(press TRUNK to program)
(press START to program)
(press TRUNK & START to program)
(press LOCK to program)
(press UNLOCK to program)
(press TRUNK to program)
(press START to program)
(press LOCK to program)
(press UNLOCK to program)
(press TRUNK to program)
(press START to program)