Excalibur AL-1670-B Operation Manual page 5

• Run Time Extender: Press the START button one time during remote start to
restart the engine run timer� The timer will restart�
NOTE: This can only be used once per remote start cycle.
• If you decide not to drive your vehicle, you can turn off the remote start using the
same method to turn it on (Default = press START twice in 5 seconds)�
NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so an
additional press is required.
• Upon entering the vehicle during remote start mode, turn the ignition key to the
"ON/RUN" position (NOT START!!)� When you press the brake pedal, the remote
start will turn off allowing the ignition key to take over�
CHANNEL 3: Press and hold the TRUNK & START buttons for 2
seconds�
CHANNEL 4: Press and hold the LOCK & TRUNK buttons for 2
seconds�
CHANNEL 5: Press and hold the UNLOCK & START buttons for 3
seconds
Controller Functions (cont'd)
• YOUR SYSTEM WILL ACTIVATE THE CH� 3 OUTPUT�
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 4
OUTPUT�
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 5
OUTPUT�
5