Connecting The Cpu/Interface Module To The Load Current Supply - Siemens SIMATIC S7-1500 System Manual

5.8

Connecting the CPU/interface module to the load current supply

Introduction
The load current supply is equipped with a plug-in 24 V DC output terminal (behind the front
cover at the bottom). You connect the wires for the supply voltage of the CPU/interface
module to this terminal.
Requirements
● Only wire the connection plug when the supply voltage is turned off.
● The connection plug for connecting the supply voltage to the CPU/interface module is
already mounted. See section Connecting the supply voltage (Page 80).
Tools required
3 to 3.5 mm screwdriver
Automation system
System Manual, 09/2016, A5E03461182-AD
5.8 Connecting the CPU/interface module to the load current supply
Wiring
83