1. Open the front panels of the power supply module and CPU.
2. Remove the strain relief clamp from the power supply module.
3. Strip the power cable to a length of approximately 11 mm and connect it to L1,
N, and to the ground conductor terminal of the power supply module.
4. Screw-tighten the strain relief clamp again.
5. You can now wire your CPU:
With &38 ,)0 , the power supply terminal connection is located on the
–
front panel of the integrated I/O.
Connect the lower terminal M of the power supply module to terminal M of
the CPU and the lower terminal L+ of the power supply module to terminal
L+ of the CPU.
&38 ,)0 '3 '3 '3 Insert the
–
connection comb and screw-tighten it.
6. Close the front panel.
The figure below illustrates the procedures described above.
Figure 7-3 Wiring the power supply module and the CPU
Table 7-5
Cable grip of the power supply
Connection comb (accessory for power supply)
1RWH
The PS 307 power supply module is equipped with two additional DC 24 V
connections (L+ and M) for the supply of I/O modules.
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
A5E00203919-01
1
1
2
230 V/120 V
Wiring accessories
7KH QXPEHUV KDYH WKH IROORZLQJ PHDQLQJV
:LULQJ
7-7