Siemens SIMATIC S7-1500 System Manual page 157

Error messages
In case of error, the WRREC instruction returns the following error messages via the
STATUS block parameter:
Table 9- 9
Error code
80B1
80B5
80E2
80B8
Automation system
System Manual, 09/2016, A5E03461182-AD
Error messages
Me aning
Invalid length; the length information in data record 196 is not correct.
H
Configuration control parameters not assigned.
H
Data record was transferred in the wrong OB context. The data record must be
H
transferred in the startup program.
Parameter error
H
Reasons for a parameter error are:
Incorrect block ID in the header (not equal to 196)
•
Invalid version identifier in the header
•
A reserved bit was set
•
A station master slot was assigned an invalid slot in the station option
•
Multiple slots in the station master are assigned to the same slot in the sta-
•
tion option
For shared device on submodule level: violation of defined restrictions
•
Flexible automation concepts
9.2 Configuration control (option handling)
157