Configuring Et 200Mp Distributed I/O System - Siemens SIMATIC S7-1500 System Manual

6.2

Configuring ET 200MP distributed I/O system

Introduction
You configure and assign parameters to the ET 200MP (interface module and I/O modules)
with STEP 7 or in the configuration software of another manufacturer.
Requirements
Table 6- 1 Requirements for installation
C o nfiguration software
STEP 7 (TIA Portal) as of V13
STEP 7 V5.5 SP3 or higher
Software of another manufacturer
The TIA Portal supports GSDML specification V2.25. The ET 200MP is delivered with a GSD file based on specification
1)
V2.3. The GSD file can be installed and used in the TIA Portal.
Reference
You can find an overview of the most important documents and links for the TIA Portal in the
following FAQ on the Internet
(https://support.industry.siemens.com/cs/de/de/view/65601780/en).
Configuring operation on PROFIBUS DP using a GSD file
If you want to configure the operation on the PROFIBUS DP using GSD file, note the
following additional requirements:
Table 6- 2 Requirements for PROFIBUS DP with GSD file
I/O modules
Input/output modules 35 mm
Input/output modules 25 mm
Technology modules (TM)
Communications modules CM PtP
Automation system
System Manual, 09/2016, A5E03461182-AD
R e quirements
IM 155-5 PN ST and IM 155-5 DP ST: as of firmware
1)
version V2.0.0
IM 155-5 PN HF: as of firmware version V1.0.0
PROFINET IO GSD file: GSDML-Vx.y-siemens-
et200mp-"Date in format yyyymmdd".xml
(http://support.automation.siemens.com/WW/view/en/19
698639/130000)
PROFIBUS DP GSD file: SI0xxxxx.gsx
(http://support.automation.siemens.com/WW/view/en/10
805317/133300)
R e quired firmware version
IM 1 55-5 DP ST as of ...
V1.0.0
V2.0.0
V2.0.0
V1.0.0
6.2 Configuring ET 200MP distributed I/O system
In stallation information
STEP 7 online help
STEP 7 online help
Manufacturer documenta-
tion
R e quired firmware version I/O modules
a s o f ...
V2.0
V1.0
V1.1
V1.0.1
Configuring
115