E-Log (Error Code Log) - Henny Penny LVG-102 Technical Manual

4-1. ADVANCED PRODUCT
SETTINGS (Continued)

4-2. E-LOG (error code log)

Feb. 2011
8. Press button until "FULL HT" shows in display along
with full heat value in seconds, which means heat is on as
soon as a timer button is pressed, for a programmed length
of time. Press product buttons
to change this value of 0 to 90 seconds.
9. Press button until "PC FACTOR" shows in display
along with the proportional temperature, which helps keep
the oil from over-shooting the setpoint temperature. Press
product buttons
value of 0 to 50 degrees.
• Use button to go back to previous menu items.
• Press X button when finished with the current product, to
return to the PRODUCT SELECTN step.
• Press X button a second time to exit PROD COMP mode.
1. Press and hold
shows in the display, followed by ENTER CODE.
2. Enter code 1, 2, 3, 4 (first 4 product buttons). "PROD"
and "COMP" show in the displays.
3. Press button and "E-LOG" shows in the display.
4. Press right √ button and "A" plus the present date & time
flashes on the display, along with "*NOW*".
5. Press and if an error was recorded, "B" and date, time,
and error code information shows in display. This is the
latest error code that the controls recorded.
6. Press and the next latest error code information can be
seen. Up to 10 error codes (B to K) can be stored in the
E-Log Section.
Press and hold the right √ button to view a brief description
of the error.
4-2
Model LVG-102, 103, 104
to change this
and buttons until LEVEL - 2