Henny Penny LVG-102 Technical Manual page 30

5-2. SPECIAL PROGRAMMING
(Continued)
Feb. 2011
Decal Layout (SP-8)
9. Press button and "SP-8 DECAL LAYOUT?" scrolls in the
left display. The words in the right displays should match the
arrow type above the
EX: If the control decal shows
should show DOWN-UP
If the displays show UP-DOWN, use the
change the displays to DOWN-UP.
Liquid or Solid Cooking Oil Used (SP-10)
10. Press button and "SP-10 MELT CYCLE SELECT"
scrolls in the left display. Unless solid oil is being used in the
vats the right display should show "1.LIQUID".
If solid oil is used, the unit MUST BE equipped to handle solid
oil. Use the and
"2.SOLID"
Change Pad Reminder Time (SP-12)
11. Press button and "SP-12 'CHANGE PAD' REMINDER"
shows on the display. Use the product buttons
changing the filter pad reminders.
For example, if "25 HRS" is programmed in the right display,
every 25 hours the display shows "CHANGE PAD" as a
reminder to the operator that the filter pad needs changed.
Pan Out of Fryer = Pad Changed (SP-13)
12. Press button and "SP-13 PAN OUT = CHANGED PAD"
scrolls in the left display. Use the product buttons
drain pan is pulled-out from under fryer before the controls
reset the change pad reminder. This is the amount of time it
should take to change filter pad. The range is 15 to 255
seconds.
For example, if "120 SEC" is programmed in the right display,
when the drain pan is out from under the fryer for at least 120
seconds, the controls restarts counting for the change pad
reminder.
Auto-Fill Enabled (SP-14)(automatically keeps oil at proper level)
13. Press button and "SP-14 AUTO-FILL ENABLED?"
scrolls in the left display. Use the
right display to "YES" or "NO".
This should always be set to "YES", unless a hardware failure
causes a problem, such as a JIB pump or Add Oil valve failure.
5-5
Model LVG-102, 103, 104
and buttons.
the right displays
and
buttons to change the right display to
to change the time between
to program amount of time the
and buttons to set the
buttons to