Henny Penny LVG-102 Technical Manual page 28

5-2. SPECIAL PROGRAMMING
(Continued)
Feb. 2011
SP-41 • Max. Bubble PSI - XX.XX PSI
SP-42 • Max. Wash Time - XXXX SEC
SP-43 • Old Pad Max. Wash Time - XXXX SEC
SP-44 • Min. Fill Time - XXX SEC
SP-45 • New Pad Max. Fill Time - XXXX SEC
SP-46 • Old Pad Max. Fill Time - XXXX SEC
SP-47 • Required Bubble PSI Hits - XXX CNT
SP-48 • Pressure Trip Limit - XXX PSI
SP-49 • Pilot During Filter-PILOT OK or NO PILOT (GAS
FRYERS ONLY)
SP-50 • Filling - Low Heat On - XXX SEC
SP-51 • Filling - Low Heat Off - XXX SEC
SP-52 • Heat Error Enabled? - YES or NO
SP-53 • Warm Return Line Enabled?/Interval - H:MM
(Hours/Minutes - OFF to 4 hours)
SP-54 • Warm Return Line Time - M:SS
(Minutes/Seconds - 0:00 to 4 Minutes)
SP-55 • Enable R & D Displays? - YES or NO
Not all Special Program Mode functions are discussed in this
section. To ensure proper operation of fryer, please consult
Henny Penny Corp. before changing any of these settings. For
more information on these functions, contact the Service
Department at 1-800-417- 8405, or 1-937-456-8405.
To Enter Special Programming:
1. Press and hold
shows in the display, followed by ENTER CODE.
2. Enter code 1, 1, 2, 2, 1, 1, 2, 2 (first 2 product buttons).
3. "A. TECH" & "RESETS" show in displays. Press
and "B. SPCL" & "PROG" show in the displays.
Zone - USA/Non-USA (SP-1)
4. Press √ button and "SP-1 ZONE" shows in the left display.
Use and buttons to set the default set-points to USA
specifications or non-USA specifications.
Initialize System (SP-2)
5. Press button and "SP-1 DO SYSTEM INIT" scrolls in
left display. To reset the controls to factory default settings,
press and hold √ button and controls count down "IN 3",
"IN 2", "IN 1". Once display shows "-INIT-" & *DONE*
the controls are reset to factory defaults.
5-3
Model LVG-102, 103, 104
and buttons until LEVEL - 3