JUKI MEB-3200 Engineer's Manual page 97

1. Cloth cutting knife 6 which can be used is up to the same length as that supplied with each presser
set.
In addition, sewing size (cut length + taper bar length) is as described below :
1) Presser set S : 16 to 24 mm (26 mm)
2) Presser set M : 24 to 32 mm (34 mm)
3) Presser set L : 32 to 40 mm (42 mm)
* Sewing length may be limited by the data compensation in terms of sewing length.
(Example) In case compensation of number of stitches at sewing end (No. 9) is +1 stitch, the maximum
sewing length is limited shorter as many as 1 stitch.
* In case ROM is after 010A, sewing of taper bar and without bar only can be performed up to the
length in parentheses ( ).
* In case a cloth cutting knife longer than the cloth cutting knife size which can be used is used, the
knife interferes with upper knife lower cover !1 at the time of thread trimming.
Replace the cloth cutting knife with the one which is in the range of size, or cut the cloth cutting knife.
2. When attaching upper knife lower cover !1 , assemble it in the proper position referring to "(15) Adjusting
the short thread trimming".
3. Fitting screw !6 , bending washer !5 and setscrew !0 are included in the presser set as spare parts.
4. After replacing the presser set, perform the change of DIP switch according to the sewing size of the
corresponding presser set. If the sewing size outside the range of the presser set is sewn with the
wrong setting, knife unit 9 or upper knife lower cover ! 1 interferes with needle, or thread trimming
failure will be caused.
Caution in assembling
93
− −