JUKI MEB-3200 Engineer's Manual page 8

Name
NO.
!1
RIGHT " – " key
!2 RIGHT " + " key
!3
PATTERN key
!4
DATA key
!5
COUNTER key
!6
NEEDLE key
!7
LOOPER key
!8
LENGTH key
!9
STITCHES
(Number of stitches
of parallel)
key
@0
STITCHES
(Number of stitches
of eyelet)
key
@1
SPACE
(Cut space)
key
@2
S P A C E
( E y e l e t
space) key
Note 1 : When changing the set value, operate the panel in the state that the sewing LED has gone out.
Note 2 : When both the before-cut and after-cut knives are not selected (set value : "0"), the data without knife
is selected.
Note 3 : Effective / ineffective of knife operation can be selected in case of the before-cut and after-cut knives,
however, in case of the data without knife, the knife operation cannot be performed.
Description
This key subtracts various
data.
This key adds various data.
This key performs display
and setting of pattern No.
This key performs display
and setting of DATA No.
This key performs display
and setting of counter.
This key performs display
and setting of needle thread
tension data.
This key performs display
and setting of looper thread
tension data.
This key sets the length to
be sewn.
Note 1
This key sets the number of
stitches of the parallel
section.
Note 1
This key sets the number of
s t i t c h e s o f t h e e y e l e t
section.
Note 1
This key sets clearance
between cloth cutting knife
and sewing at the parallel
section. Note 1
This key sets clearance
between cloth cutting knife
and sewing at the eyelet
section. Note 1
−
Name
NO.
@3
LENGTH
(Taper bar
length) key
Note 1
@4
STITCHES
(Number
of stitches
of taper bar)
key
@5
OFFSET
(Taper bar
offset) key
@6
MAX
(Sewing
speed) key
@7
EYELET
(Eyelet speed
setting) key
@8
KNIFE
(Knife ON/
OFF)key
@9
CB
(Before-cut
knife) key
#0
CA
(After-cut
knife) key
#1
SHAPE
(Knife No.)
key
#2
AUTO
(Auto
operation)
key
#3
OPEN
(Cloth
open) key
#4
ADJUST
(Knife adjust)
key
#5
FUNCTION
(Function) key
4
−
Description
This key sets sewing length
of taper bar.
Note 1
This key sets the number of
stitches of taper bar.
Note 1
T h i s k e y s e t s t h e s l i p
amount of taper bar.
Note 1
This key performs setting of
sewing speed.
Note 1
This key performs setting of
reduced speed at eyelet
section.
Note 1
This key sets effective/
ineffective of knife.
Note 3
This key performs data
setting of before-cut knife.
Note 2
This key performs data
setting of after-cut knife.
Note 2
This key selects the No. of
kind of knife to be used.
Note 1
This key performs change-
over of automatic and
manual operation modes.
The mode becomes the one
operating with the cloth open
mechanism opened.
The mode becomes the one
o f c l o t h c u t t i n g k n i f e
adjustment by turning ON
the power with this key held
pressed.
This key can be changed to
optional data setting function
key with the memory switch.
At the time of delivery
F1 : Knife position adjustment (No. 8)
F2 : Copy destination No. (No. 80)