1. The marking light cannot be installed to RS and RD types.
2. Do not watch directly the beam of laser marking projector 1.
3. Adjust so that the top end of laser marking projector 1 should protrude approximately 13.5 mm
from marking light installing base 2.
4. When attaching the marking light on the machine arm, set cable 1 -a of laser marking projector 1
to the underside of marking light installing plate boss 7 so that the cable is not caught in the
machine arm.
8
5. When attaching the marking light on the machine arm, if the center of section D of marking light
installing plate 4 is moved approximately 7 mm to the right side as viewed from the face section,
set marking light installing plate bosses 7 as shown figure.
Caution in assembling
13.5mm
1
7
7
7
7
4
87
−
−
2
8
1 -a
7
8
8