JUKI MEB-3200 Engineer's Manual page 165

Adjustment Procedures
1) Setting the knife No.
1. Set the knife No. of the same form as that of the knife mounted
on the sewing machine and determine the multicutting
operation.
2. Set the knife No. with RIGHT
In case of the multicutting device set 13 (standard) or 16
(optional).
However, setting can be performed up to No. 11 to 16 in the
list and by setting the optional knife No., it is possible to perform
sewing by increasing or decreasing the eyelet shape in terms
of the form of eyelet knife mounted on the sewing machine.
[When performing the decorative buttonhole sewing, set "Plural
times selection : data No. 83" to "1" and change the respective
sewing data without changing the knife No. to perform the
sewing.]
(Caution) In case of setting knife Nos. 0 to 6, the knife operates
only once.
2) Cut length compensation
1. Cut length in terms of the sewing length can be shortened.
2. Set the cut length with RIGHT
! 2 . The length can be set in increments of 1 mm up to 0 (cut
length - knife holder length).
key ! 1 or RIGHT key ! 2 .
key !1 or RIGHT
key
161
− −
Results of Improper Adjustment