JUKI MEB-3200 Engineer's Manual page 83

1. Perform the alignment of marker dot V on cloth cutting direct drive gear 8 with marker dot W on cloth
cutting direct drive metal !0 .
2. Adjust the tapered sections of setscrew A 4 in the cloth cutting lever and setscrew A 6 in cloth cutting
direct drive gear to tapered holes, T and U in cloth cutting driving shaft 9 respectively.
!0
W
When the combination of the type (SS/RS, or JS/CS/TS) and the cloth cutting plate (A, or B) is wrong,
discharge of cloth chips may not be performed well.
Cautions in assembling
V
9
8
Cautions in assembling
79
−
4
5
T
2
8
−
6
9
7
U