Adjustment Procedures
4) Decorative buttonhole offset
1. Clearance from the top of the stitches of decorative buttonhole
to the cutting position can be set.
2. Set the clearance with RIGHT
! 2 .
The clearance can be set in increments of 1 mm up to 0 (cut
length - knife holder length - cut length compensation value).
It is effective only when the data No. 82 is "1".
Adjustment Procedures
1. Start the memory switch. (READY key + Power ON)
2. Set the memory switch Nos. H9 to J6 in accordance with the
knife holder length and knife No. as listed in the table below.
(Standard value at the time of knife holder length = 18 mm)
(Caution) It is effective only when knife Nos. 11 to 16 are
selected.
key ! 1 or RIGHT
key
165
−
−
Results of Improper Adjustment
Results of Improper Adjustment