JUKI MEB-3200 Engineer's Manual page 95

Adjustment Procedures
1. Loosen two marking light installing base setscrews 5.
2. Move marking light installing base 2 in the direction of arrow
mark and adjust it so that the laser beam lights on the center of
needle.
1. Loosen two marking light installing base setscrews 8.
2. Move marking light installing plate 4 up or down, or in the
direction of rotation as the arrow marks and adjust it so that
the laser beam reaches the origin position being used.
3. If the adjustment of the position of marking light installing plate
4 only is insufficient, loosen two laser marking projector
setscrews 3, move laser marking projector 1 in the direction
of arrow mark and adjust it so that the laser beam can reach
the origin position being used.
(Caution) Adjust the protruding amount of laser marking
projector 1 from the marking light installing base 2 to 15
mm or less.
Results of Improper Adjustment
™ When the laser beam is laterally
slipped :
1. Laser beam does not correspond
with the sewing position.
91
− −