JUKI MEB-3200 Engineer's Manual page 141

■ Without looper thread trimmer (Memory switch No. 22 = 0)
Knife holder
length (mm) Eyelet buttonhole (mm)
18
26
32
* Min. stitch length is the same as that with looper thread trimmer.
Caution 2. Be sure to use the knife holders exclusive for the multicutting device (32087801, 32087702,
32087603, 32088106, 32088007 and 32087900).
In addition, be careful of the clearances between the knife holder and the right/left presser
feet. (The knife holder may come in contact with the presser holding plate at the time of
cloth cutting.)
Caution 3. Stitch bite width and needle No. are set as follows at the time of delivery from the factory.
Stitch bite width : 2.8 mm
Needle No. : #100
(When changing the stitch bite width or the needle No., make sure of the installing
positions of needle and looper, and the spreaders, the timing to open/close the spreaders,
and the clearance between the needle and the needle guard.)
Caution 4. The range of stitch bite width can be changed from 2.0 to 3.2 mm to 2.6 to 4.0 mm by
changing the optional left looper and the optional left spreader.
Caution 5. When the cut-before knife is selected, the knife holder may come in contact with the presser
and the presser holding plate if the clearances between the knife holder and the right/left
presser feet are small.
Caution 6. When installing the multicutting device after set-up of the machine, replace the ROM with
one described below. (Part No. : HL010523011, Rev : 011G)
Max. stitch length
Decorative buttonhole (mm)
38
46
50
137
−
38
46
50
−