Examining Ram Movement - LELY WELGER AP 530 Operator's Manual

34
Figure 43
Figure 44
LELY WELGER AP 530 AP 630
Packer quick adjustment
A good bale shape largely depends on even filling of the baling
AP 530
channel by the packer. To achieve a good bale shape with
different crop materials, baling channel filling can be altered by
repositioning the Iinchpin in the perforated link plate on the
packer rod linkage:
AP 530 (Figure 43)
AP 630/AP 730
AP 830 (Figure 44)
Secure pin 33 or 34 with the guard pin. By adjusting the

tines on the packer and cross-feeder, it is also possible to
influence the way material is fed into the baling channel.
Packer tines higher: bales on knife side are firmer.

33
B
A
5.2.6
Clean off baling material compressed onto the slide rails.

Check that the ram pins are tight.

Clean, examine and, if necessary, replace all rollers and

slide rail scrapers on the dismantled ram.
Have the ram slide rails in the frame of the machine readjusted
only by a specialist workshop.
AP 730 AP 830
denser filling in driving direction
left
pin 34 in lower
holes
pin 33 in right hole
A

Examining ram movement

Note!
right
pin 34 in upper
holes
pin 33 in right hole
B
63