Yealink SIP-T48S User Manual page 250

User Guide for the SIP-T48S IP Phone
If the voice mail pop-up message box disappears, it won't pop up again unless the user receives
a new voice mail or the user re-registers the account that has unread voice mail(s).
Note You can configure the phone not to display the pop-up prompt, contact your system
administrator for more information.
The icon on the status bar has a counter indicating the number of messages you haven't
heard yet.
To leave a voice mail:
You can leave a voice mail for someone else when he/she is busy or inconvenient to answer the
call. Follow the voice prompt from the system server to leave a voice mail, and then hang up.
To configure voice mail access codes via phone user interface:
Tap ->Message->Set Voice Mail Code.
1.
Enter the voice mail access code (e.g., *4) in the desired account field.
2.
You can tap the IME soft key to change the input mode.
Tap the Save soft key to accept the change or
3.
Voice mail access codes must be predefined on the system server. Contact your system
Note
administrator for the more information.
To listen to voice mails:
When the touch screen prompts that the phone receives a new voice mail, you can press
1.
or tap Connect to dial out the voice mail access code.
Follow the voice prompt to listen to your voice mails.
2.
240
to cancel.