Call Park - Yealink SIP-T48S User Manual

User Guide for the SIP-T48S IP Phone
Click Confirm to accept the change.
5.
Note
Network conference is configurable via web user interface only.
To set up a network conference call:
Place a call to the first party.
1.
Tap the Conference soft key to place a new call.
2.
The active call is placed on hold.
Enter the number of the second party and then press
3.
When the second party answers the call, tap the Conference soft key to add the second
4.
party to the conference.
Tap the Conference soft key to place a new call.
5.
The conference call is placed on hold.
Enter the number of the new party and then press
6.
When the new party answers the call, tap the Conference soft key to add the new party to
7.
the conference.
Repeat steps 5 to 7 until you have added all intended parties.
8.
The procedures to set up a network conference call on specific servers may be different from
introduced above. Contact your system administrator for more information.

Call Park

You can use call park feature to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You can park
an active call by tapping the Park soft key or pressing call park key (if configured) on the phone.
If the call is parked successfully, there is a voice prompt confirming that the call was parked. You
can retrieve the parked call by pressing the Retrieve soft key or the retrieve key (if configured).
If the parked call is not retrieved within a period of time defined by the system, the phone performing
call park will receive the call back.
Note Call park is not available on all servers. Contact your system administrator for more information.
The IP phone supports call park feature under the following modes:
FAC mode: park the call to the local extension or a desired extension through dialing the

park code, and retrieve the parked call from the local extension or desired extension
through dialing the park retrieve code.
Transfer mode: park the call to shared parking lot through performing a blind transfer to

a call park number (call park code), and retrieve the parked call from the shared parking lot
through dialing the park retrieve code.
168
, , or tap the Send soft key.
, , or tap the Send soft key.