Attended Transfer; Call Waiting - Yealink SIP-T48S User Manual

User Guide for the SIP-T48S IP Phone

Attended Transfer

Before performing an attended transfer (except you use dial number method), make sure that
the transfer mode on DSS key is configured as New Call or Attended Transfer. For more
information on how to configure it, refer to
185.
To perform an attended transfer:
Press
1.
Do one of the following:
2.
Enter the number you want to transfer the call to.
-
Press
Tap the Directory soft key, and then tap All Contacts. Search for the contact and tap
-
the desired contact to dial out.
- Tap the Directory soft key, and then tap Remote Phone Book. Search for the contact
and tap the desired contact to dial out. (Directory and remote phone book should be
configured in advance. Refer to
page
Tap the History soft key, and then tap the desired list. Tap the desired entry to dial
-
out.
After the party answers the call, press
3.
If you are using a handset, the transfer can be completed by hanging up the handset.

Call Waiting

You can enable or disable call waiting on the phone. If call waiting is enabled, you can receive
another call when there is already an active call on the phone. Otherwise, another incoming call
is automatically rejected by the phone with a busy message when there is an active call on the
phone. You can also enable or disable the phone to play a warning tone when receiving another
call.
To configure call waiting via phone user interface:
Tap ->Features->Call Waiting.
1.
Tap the On radio box of the Call Waiting field.
2.
Tap the On radio box of the Play Tone field.
3.
(Optional.) Enter the call waiting on code or off code respectively in the On Code or Off
4.
Code field.
164
or tap the Transfer soft key during a call.
or to dial out.
89 for more information.)
Configuring Transfer Mode on DSS Key
Directory on page 68 and
or tap Transfer to complete the transfer.
on page
Remote Phone Book on