Locking Power Cord - For Iec Type Pdu; Input Power Cord; Output Power Cord; Electrical Installation - CyberPower PDU81001 User Manual

Installation Guide

Locking Power Cord - For IEC Type PDU

Input Power Cord

Step 1. Align and insert the Cable Tie from the upper side of the
Fixed Stand and fasten it as shown below.
Step 2. Align and insert the Cable Tie from the bottom side of the
Fixed Stand and fasten it as shown below.

Output Power Cord

Step 1. Align and insert the Cable Tie from the upper side of the
Fixed Stand and fasten it as shown below.

Electrical Installation

Step 1. Receptacle evaluation
Ensure that the plug type of your PDU unit matches the wall
receptacle type that you are using.
Step 2. Plug the PDU into a CyberPower UPS system (recommended)
or the wall receptacle.
Step 3. Attach equipment
It is extremely important not to exceed the PDUs maximum
current load (as outlined in the Specifications section). In
order to determine your total load, simply use the LCD screen
on the front of the PDU to monitor the load being attached.
The PDU must be plugged into a three-wire, grounded wall receptacle
only. The wall receptacle must also be connected to an appropriate
branch circuit/main with fuse or circuit breaker protection. Connection
to any other type of wall receptacle may result in a shock hazard.
20