Operation; Metered Readout; Basic Operation; Pdu Status Screen - CyberPower PDU15SW8FNET User Manual

Installation Guide
4. Type "setup" and press Enter to enter the Authentication menu.
5. Enter the user name and password of the PDU device at the Authentication menu.
Note: The default username is "cyber" and the default password is "cyber".
For further information and configuration via Hyper Terminal, see Appendix
A-Hyper Terminal.

Operation

Metered Readout

B1 B2
- Normal
YU0-0000028-00
- Warning
- Overload
Amps
Volts
Select
KW
Reset

Basic Operation

Screen Selection- To toggle the different status screens, press the Select button
next to the PDU status screen.
• Pressing the Select button once will toggle to the next status screen.
• Pressing and holding the Select button for 3 seconds will display the local IP
address of the unit.
• Pressing and holding the Select button for 6 seconds will enter the outlet
control mode.

PDU Status Screen

• Current Level
• Input Voltage

• Power

• IP Address
• Outlet Control (switched series only)
• LED Reversal (0U series only)
The LED status screen can be set to display upside down from standard through
the Web Interface (as shown in figures below). Note: the decimal point will not
be moved and will instead be on the top if this option is enabled.
For more information on CyberPower products, visit www.CPSww.com
The Metered Readout provides instant status updates of
Tx/Rx
the PDU's Voltage, Current, Power conditions as well as
Link
the local IP address of the unit to the user. In addition, it
also allows the user to control each outlet of the PDU.
The Current Level screen shows the total current draw of
the connected equipment. Units are listed in Amps.
The Input Voltage screen measures the AC voltage that the
system is receiving from the utility wall receptacle. This
can be used as a diagnostic tool to identify poor-quality
input power. Units are listed in Volts.
The Power screen shows the total power that the devices
connected to the PDU consumes. Units are listed in kilowatts.
The IP Address screen displays the local IP address of the
PDU unit. Note: If the PDU is not connected to a LAN, the
readout will display the default IP address.
The Outlet screen shows the condition of each outlet in
sequence. When the outlet is on, the light below this
outlet will be on and a square appears in the upper right
area next to the number of the outlet. To switch the outlet
off, press the Select button once and the square will move
to the lower right. After 1 second, the outlet will turn off.
17