Jeep cherokee 1989 Owner's Manual page 250

9-4
caliper out of the anchor plate, then
remove the caliper completely. Take this
opportunity t o check for fluid leakage
around the caliper piston boot, which
would indicate the need t o overhaul the
calipers (see Section 4)
.
Pull the anti-rattle clips away
from the pad with your index fingers
and force the inner brake pads out
with your thumbs
pad on the anchor plate and push i t
down against the anti-rattle clip, then lift
up on the upper anti-rattle clip and
swing the pad into position
The Motor Manual Guy
9
Chapter Brakes
Once the caliper is removed from
the anchor plate, hang i t from the coil
-
spring with a piece of wire DON'T let
i t hang by the brake hose!
Before installing the brake pads,
clean the sliding surfaces on the caliper
and anchor plate and apply a thin coat
of high-temperature grease t o the
anchor plate in the area shown
of the caliper with the anchor plate,
then rotate over the pads
it
Pry downward on the lower
anti-rattle clip and remove the
outer brake pad
the anchor plate and install the
inner brake pad
Lubricate the mounting pins with
high-temperature grease, push them into
the caliper and tighten them to the
specified torque