61-10
BEZEL
ATTACHING
SCREWS
SNAP FIT
LOCATIONS
1 6 . 4 The instrument cluster bezel is held in place by four
screws and is a snap fit
Instrument cluster bezel
Remove the attaching screws and unsnap the bezel at the snap
4
f i t locations in the dash (see illustration).
5
Remove the bezel.
6
lnstallation is the reverse of removal.
Radio and heater control panel
Remove the attaching screws and pull the panel assembly out (see
7
illustration).
8
Unplug the electrical connectors and remove the assembly.
9
Installation is the reverse of removal.
The Motor Manual Guy
Chapter 11 Body
SNAP FIT
LOCATION
\
1 6 . 1 0 The left side of the defroster cowl is retained by a clip
Defroster cowl panel
10 Remove the screws, detach the retaining clip on the driver's side
and lift the c o w l panel out (see illustration).
11 Installation is the reverse of removal.
1 7
Center console
Refer to illustration 1 7.3a, 1 7.36, 1 7.4a and 1 7.46
1
Disconnect the negative cable at the battery.
16.7
Dashboard panel installation details
-
removal and installation