Jeep cherokee 1989 Owner's Manual page 143

Cut the retaining strap that holds the blower/evaporator housing
8
to the heater core housing (see illustration).
Disconnect the heater control cable (see illustration 11.8).
9
the retainina screws (see illustration 11.8).
. .
1 1 Remove the housing attaching nuts from the studs on the engine
compartment side of the firewall (see illustration).
12 Remove the evaporator drain tube.
13 Remove the right kick panel and then the instrument panel support
bolt.
11.7 Blower housing components
2 Blower motor resistors
1 1 . I 1 Remove the housing attaching nuts
The Motor Manual Guy
Chapter 3 Cooling, heating and air conditioning systems
-
with air conditioning
3 Air conditioning thermostat
4 Vacuum motor
down and toward the rear of the vehicle to disengage the housing studs
from the dash panel. Then remove the blower/evaporator housing.
heater core by pulling it straight down out of the housing.
16 Position the heater core in the housing and install the screws. Be
sure to cement the seal in place to keep it from moving when the blower
assembly is installed (see illustration 11 . I 5 ) .
Cut the retaining strap (5) and remove the heater
11.8
control cable (6). the rear blower housing flange clip
and the retaining screws (8)
1 1.15 Remove the heater core retaining screws
installing it, cement the seal in place to keep it from
moving when the blower assembly is installed
and remove the
SCREWS
-
when
3-9
g