Editing Ip Cameras Connected To The Poe Interfaces - HIKVISION DS-9608NI-I8 User Manual

2.3.4 Editing IP Cameras Connected to the PoE Interfaces

This chapter is only applicable for the following models: DS-7600NI-I2/P, DS-7700NI-I4/P,
DS-7600NI-K2/P, DS-7700NI-K4/P and DS-7600NI-K1/4P series NVR.
The PoE interfaces enables the NVR system to pass electrical power safely, along with data, on
Ethernet cabling to the connected network cameras.
Up to 4 network cameras can be connected to /4P models, 8 network cameras to /8P models, and
16 network cameras to /16P models. If you disable the PoE interface, you can also connect to the
online network cameras. And the PoE interface supports the Plug-and-Play function.
Example:
For DS-7608NI-I2/8P, if you want to connect 6 network cameras via PoE interfaces and 2 online
cameras, you must disable 2 PoE interfaces in the Edit IP Camera menu.
 To add Cameras for NVR supporting PoE function:
Before you start:
Connect the network cameras via the PoE interfaces.
Step 1 Enter the Camera Management interface.
Menu> Camera> IP Camera
The cameras connecting to the PoE interface cannot be deleted in this menu.
Step 2 Click the
• Plug-and-Play: It means that the camera is connected to the PoE interface, so in this case,
the parameters of the camera can't be edited. The IP address of the camera can only be
Network Video Recorder User Manual
Figure 2-40 List of Connected Cameras
button, and select the Adding Method in the drop-down list.
66