Ds-7600Ni Series; Ir Remote Control Operations - HIKVISION DS-9608NI-I8 User Manual

1.1.4 DS-7600NI Series

No. Name
1 POWER
2 HDD
3 Tx/Rx
4 USB Interface

1.2 IR Remote Control Operations

The NVR may also be controlled with the included IR remote control, shown in Figure 1-7.
Batteries (2×AAA) must be installed before operation.
The IR Remote is set at the factory to control the NVR (using default Device ID# 255) without any
additional steps. Device ID# 255 is the default universal device identification number shared by the
NVRs. You may also pair an IR Remote to a specific NVR by changing the Device ID#, as follows:
Pairing (Enabling) the IR Remote to a Specific NVR (optional)
You can pair an IR Remote to a specific Hikvision NVR by creating a user-defined Device ID#. This
feature is useful when using multiple IR Remotes and NVRs.
On the NVR:
Step 1 Go to General > More Settings.
Step 2 Type a number (255 digits maximum) into the Device No. field.
Step 3 On the IR Remote:
Network Video Recorder User Manual
Figure 1-6 DS-7600NI Series
Table 1-4 Panel Description
Connections
Turns green when NVR is powered up.
Flickers red when data is being read from or written to HDD.
Flickers blue when network connection is functioning
properly.
Universal Serial Bus (USB) port for additional devices such as
USB mouse and USB Hard Disk Drive (HDD).
28