Editing Ip Cameras Connected To The Poe Interfaces - HIKVISION DS-7104NI-SL User Manual

User Manual of Network Video Recorder

2.3.3 Editing IP Cameras Connected to the PoE Interfaces

The PoE interfaces enables the NVR system to pass electrical power safely, along with data, on Ethernet cabling to
the connected network cameras.
The DS-7600NI-SN/P and DS-7100NI-SN/P series NVR provide up to 8 PoE interfaces which can connect to 8
network cameras directly; and if you disable the PoE interface, you can also connect to the online network cameras.
And the PoE interface supports the Plug-and-Play function.
Example:
As for 7604NI-SN/P NVR, when you want to connect 1 online camera and connect 3 network cameras via PoE
interfaces, you must disable 1 PoE interface in the Edit IP camera panel.
To add cameras for NVR supporting PoE function:
Before you start:
Connect the network cameras via the PoE interfaces.
Steps:
1. Enter the Camera Management interface.
2. Click the
Downloaded from www.Manualslib.com
This chapter is only applicable to the DS-7600NI-SN/P and DS-7100NI-SN/P series NVR.
Menu> Camera> Camera
You can see the connected cameras are listed.
Figure 2. 24 Camera List
The cameras connecting to the PoE interface cannot be deleted in this menu.
button, and select the Adding Method in the drop-down list.
•
Plug-and-Play: It means that the camera is connected to the PoE interface, so in this case, the
parameters of the camera can't be edited. The IP address of the camera can only be edited in the Network
Configuration interface, see Chapter 9.1 Configuring General Settings for detailed information.
manuals search engine
38