Ds-7600Ni Series; Ir Remote Control Operations - HIKVISION DS-9608NI-I8 User Manual

1.1.3 DS-7600NI Series

No. Name
1 POWER
2 HDD
3 Tx/Rx
4
USB Interface

1.2 IR Remote Control Operations

The NVR may also be controlled with the included IR remote control, shown in Figure 1. 6.
Batteries (2× AAA) must be installed before operation.
The IR Remote is set at the factory to control the NVR (using default Device ID# 255) without any additional
steps. Device ID# 255 is the default universal device identification number shared by the NVRs. You may also
pair an IR Remote to a specific NVR by changing the Device ID#, as follows:
Pairing (Enabling) the IR Remote to a Specific DVR (optional)
You can pair an IR Remote to a specific Hikvision DVR by creating a user-defined Device ID#. This feature is
useful when using multiple IR Remotes and DVRs.
On the DVR:
1. Go to General > More Settings.
2. Type a number (255 digits maximum) into the Device No. field.
3. On the IR Remote:
4. Press the DEV button.
5. Use the Number buttons to enter the Device ID# that was entered into the DVR.
6. Press Enter button to accept the new Device ID#.
Network Video Recorder User Manual
Figure 1. 5 DS-7600NI Series
Table 1. 3 Panel Description
Connections
Turns green when NVR is powered up.
Flickers red when data is being read from or written to HDD.
Flickers blue when network connection is functioning properly.
Universal Serial Bus (USB) port for additional devices such as USB
mouse and USB Hard Disk Drive (HDD).
19