Ribbon Save; Explication - Carl Valentin DYNACODE Operating Manual

Dynacode series
Layout
Transfer ribbon
without

ribbon save

Transfer ribbon
with
ribbon save
Procedure
Field ribbon save
Layout ribbon save
10.15
13 Ribbon save

13.1 Explication

Optimierung = maximum utilisation of transfer ribbon
\-----/ \--/
| |
| Layout ribbon save
|
Field ribbon save
In principle the ribbon save is achieved by the way that the transfer
ribbon in phases in those no printing is effected stopped or
decelerated. If sufficient time is available, the transfer ribbon which
was not used for printing can be retracted to print on it afterwards.
The possibility of ribbon save and in this way of the print quality are to
be connected with the available time which is needed for decelerating
and accelerating of transfer ribbon.
There are two different types of ribbon save:
It is tried to save transfer ribbon with gaps within the layout. Because
of the fact that the gaps are usually very small, only little time is
available. Therefore a feedback is not reasonable (lack of time).
The gaps between the layouts are optimised. Usually more time is
available here. The loss of transfer ribbon between the layouts which
result from accelerating and decelerating of transfer ribbon can be
corrected by means of the return.
Operating manual
Ribbon save
101