Hotstart - Carl Valentin DYNACODE Operating Manual

Additional information
Saving the
current layout
Saving the printer
order state
Loading a layout and
printer order state
100

12.3 Hotstart

Because of the fact that no battery-buffered SRAM is
available, the necessary data has to be saved in another
way, i.e. the data is saved onto Compact Flash card.
Therefore the option Compact Flash card is a condition for
the hotstart menu item.
The function hotstart contains e.g. that in case of a power failure the
currently loaded layout can be further processed without any loss of
data.
Moreover a print order can be interrupted and to be continued after
switching on the printer anew.
At an active hotstart all necessary data is stored on the
Compact Flash therefore do not remove the card during
operation. When removing during operation, this causes the
loss of all data on the Compact Flash Card.
In case the hotstart function is set to on, at the start of a print order the
data of the current layout is saved to the corresponding directory of
the Compact Flash card.
However the following conditions have to be fulfilled:

Compact Flash card inserted in drive A

Compact Flash card not write protected

Enough free storage space onto Compact Flash card
An error message appears in case these conditions are not fulfilled.
At switching off the printer the state of the current print order is saved
to the corresponding directory of the Compact Flash Card.
However the following conditions have to be fulfilled:

Compact Flash card inserted in drive A

Compact Flash card not write protected

Enough free storage space onto Compact Flash card
In case the hotstart function is set to On, at a new start of printer the
saved layout data and the print order state is loaded from the
corresponding file on the Compact Flash card. Because of this reason
a Compact Flash card has to be inserted at switching on the printer. In
case it is impossible to load the data an error message appears.
Operating manual
Dynacode series
10.15