Table of Contents
Advertisement
O
PERATION
Whites Setting
This setting allows you to select and edit the temperature of the white colors used in channel 6 (Macros)
when in the TOUR mode, channel 11 when in the TR16 and STD.Y mode, or channel 5 when in the HSIC
mode.
1.
Go to the CALIB.C main level.
2.
Enter the master access passcode as shown in
3.
Select a white color (WH.01–12)
4.
Select a color (RED, GREEN, BLUE, or WHITE)
5.
Select a color value (000–255)
6.
Repeat for the other colors
White Calibration
This setting allows you to select the white color shown by the Colorado 3 Solo when the color setting is
RGBW and the DMX controller's red, green, and blue faders are set to 255.
1.
Go to the CALIB.C main level
2.
Enter the master access passcode as shown in
3.
Go to RGBW
4.
Select a color (R., G., or B.)
5.
Select a color value (000–255)
6.
Repeat for the other colors
When selecting CALIB.C > RGBW, you will only be able to define the values of R.
(red), G. (green), and B. (blue).
The values of R. (red), G. (green), and B. (blue) configured from CALIB.C > RGBW
will define the color temperature shown when the RGB faders are set to 255 if
SETTING > COLOR > RGBW is active.
Color Temperature Settings
This setting controls the color temperature with preset white output options when all color faders are set to
100%.
1.
Go to the SETTING main level
2.
Enter the master access passcode as shown in
3.
Select FULL POWER CCT
4.
Choose a white output color temperature. (WARM WHITE, NEUTRAL WHITE, COOL WHITE#1,
COOL WHITE#2, or NORMAL)
Zoom Mode
These settings are to be changed when operating in environmental temperatures lower than 40 °F. The
default setting for normal operating temperatures above 40 °F is ZOOM MODE 1.
1.
Go to the ZOOM MODE main level
2.
Select ZOOM MODE 1 for use in normal operating temperature environments or ZOOM MODE 2
environmental temperatures lower than 40 °F.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Colorado 3 Solo.
1.
Go to the SETTING main level
2.
Enter the master access passcode as shown in
3.
Select PWM
4.
Choose an output frequency. (600Hz, 1200Hz, 2000Hz, 2400Hz, 6000Hz, or 25000Hz)
Colorado 3 Solo User Manual Rev. 2
Passcode
Passcode
Passcode
Passcode
Page 24 of 30
Advertisement
Table of Contents
