Table of Contents
Advertisement
Operation
Whites Setting
White Calibration
Static Color
Color
Temperature
Settings
Zoom Mode
LED Frequency
Software
Information
RDM
-14-
This setting allows you to select and edit the temperature of the white colors used in channel 6
(Macros) when in the TOUR mode, channel 11 when in the TR16 and STD.Y mode, or
channel 5 when in the HSIC mode.
1. Go to the CALIB.C main level.
2. Enter the master access passcode as described in Passcode.
3. Select a white color (WH.01–12).
4. Select a color (RED, GREEN, BLUE, or WHITE).
5. Select a color value (000–255).
6. Repeat for the other colors.
This setting allows you to select the white color shown by the COLORado 1 Solo when the color
setting is RGBW and the DMX controller's red, green, and blue faders are set to 255.
1. Go to the CALIB.C main level.
2. Enter the master access passcode as described in Passcode.
3. Go to RGBW.
4. Select a color (R., G., or B.).
5. Select a color value (000–255).
6. Repeat for the other colors.
When selecting CALIB.C > RGBW, you will only be able to define the values of R. (red),
G. (green), and B. (blue).
The values of R. (red), G. (green), and B. (blue) configured from CALIB.C > RGBW will
define the color temperature shown when the RGB faders are set to 255 if SETTING >
COLOR > RGBW is active.
The Static Color mode allows for permanent RGBW color mixing without a DMX controller.
1. Go to the STATIC main level.
2. Select the desired color or effect (RED, GREEN, BLUE, WHITE, STROBE, or ZOOM).
3. Select the color or effect value (000–255 for colors, strobe, and effect).
4. Repeat for the other colors or effects.
This setting controls the color temperature with preset white output options when all color faders
are set to 100%.
1. Go to the SETTING main level.
2. Enter the master access passcode as described in Passcode.
3. Select FULL POWER CCT.
4. Choose a white output color temperature. (WARM WHITE, NEUTRAL WHITE, COOL
WHITE, or NORMAL)
These settings are to be changed when operating in environmental temperatures lower than
40 °F. The default setting for normal operating temperatures above 40 °F is ZOOM MODE 1.
1. Go to the ZOOM MODE main level.
1. Select ZOOM MODE 1 for use in normal operating temperature environments or
ZOOM MODE 2 environmental temperatures lower than 40 °F.
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the
COLORado 1 Solo.
1. Go to the SETTING main level.
2. Enter the master access passcode as described in Passcode.
3. Select PWM.
4. Choose an output frequency. (600Hz, 1200Hz, 2000Hz, 2400Hz, 6000Hz,or 25000Hz)
This option shows what version of software the COLORado 1 Solo is running.
1. Go to the INFO main level.
2. Select VERSION and the version number will show on the screen.
This option shows the product's UID # and the product name.
1. Go to the RDM main level.
2. Select UID and the version number will show on the screen.
3. Select LABEL and the product name will show on the screen.
COLORado 1 Solo User Manual Rev. 1
Advertisement
Table of Contents
