Whites Setting; White Balance; Fan Setting - Chauvet ColorDash Batten-Tri User Manual

Whites Setting

White Balance

Fan Setting

COLORdash™ Batten-Tri User Manual Rev. 02a
Continued from previous page
This setting allows the user to select and edit the temperature of the white colors used
in channel 5 (Macros) when in the TOUR mode.
1) Go to CALIB1.
2) Select a white color (WHITE 01~11).
3) Select a color (RED, GREEN, or BLUE).
4) Select a color value (0~255).
5) Repeat for the other colors.
This setting allows the user to define the maximum RGB values (white balance) when
RGB to White is active.
1) Go to CALIB2.
2) Select RGB TO W.
3) Select a color (RED, GREEN, or BLUE).
4) Select a color value (0~255).
5) Repeat for the other colors.
The values of RED, GREEN, and BLUE configured from CALIB2 > RGB TO W will
define the color temperature shown when the RGB faders are set to "255" if
SETTING > COLOR > RGB TO W is active.
1) Press <MENU> repeatedly until FANS shows, and press <ENTER> to accept.
2) Use <UP> or <DOWN> to select a setting (OFF, LOW, NORMAL, HIGH, or
AUTO).
·
When in AUTO, the fan speed automatically changes so the fixture's
temperature does not exceed the upper limit.
·
When in the other settings, the fan speed follow the predefine values.
·
The internal controller will override any manual setting if the internal
temperature rises above a certain level.
End of Programming
Operation
-11-