Table of Contents
Advertisement
Configuration (DMX)
Use DMX configurations to operate the product with a DMX controller.
DMX Personalities
This setting allows you to choose a particular DMX personality.
1.
Go to the PERSONALITY main level
2.
Select the desired personality (TOUR, TR16, STD.Y, HSIC, or SSP).
•
See the
for each personality.
•
Make sure that the starting addresses on the various products do not
overlap due to the new personality setting.
DMX Control
In this mode, each product will respond to a unique starting address from the DMX controller. All products
with the same starting address will respond in unison.
1.
Select a DMX personality as shown in
2.
Set the running mode:
a.
Go to the RUN MODE main level
b.
Select the DMX programming level
3.
Set the starting address:
a.
Go to DMX Address main level
b.
Select the starting address (001–512)
The highest recommended starting address for each DMX mode is as follows:
DMX Personality
TOUR
STD.Y
SSP
Loss Of Signal Setting
This setting controls how the product will respond when the DMX signal is lost.
1.
Go to the SETTING main level
2.
Enter the master access passcode as described in
3.
Select DMX ERROR
a.
Select SAVE to make the product use the last command used when the signal is lost
b.
Select BLACK to turn off the all the LEDs when the signal is lost
Page 13 of 30
DMX Values
section for the highest starting address you can select
DMX Personalities.
DMX Address
501
496
504
DMX Personality
TR16
HSIC
Passcode
Colorado 3 Solo User Manual Rev. 2
O
PERATION
DMX Address
496
504
Advertisement
Table of Contents
